Bauknecht BIR6 MP8TS3 PT Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 5)

EN

5

contact gap of 3 mm is required

and the appliance must be

earthed.

If the power cable is damaged,

replace with an identical one. The

power cable must only be replaced

by a qualied technician in

compliance with the manufacturer

instruction and current safety

regulations. Contact an authorized

service center.

It must be possible to

disconnect the appliance from

the power supply by unplugging

it if plug is accessible, or by

means of an accessible multi-

pole switch installed upstream

of the socket in conformity with

national electrical safety

standards.

The rating plate is on the front

edge of the oven (visible when

the door is open).

In case of replacement of power

cable, contact an authorized

service center.

If the tted plug is not suitable

for your socket outlet, contact a

qualied technician.

The power cable must be long

enough to connect the

appliance, once tted in its

housing, to the main power

supply. Do not pull the power

supply cable.

Do not use extension leads,

multiple sockets or adapters.

Do not operate this appliance if

it has a damaged mains cord or

plug, if it is not working

properly, or if it has been

damaged or dropped. Keep the

cord away from hot surfaces.

The electrical components must

not be accessible to the user

after installation.

Do not touch the appliance with

any wet part of the body and do

not operate it when barefoot.

CLEANING AND

MAINTENANCE

Never use steam cleaning

equipment.

WARNING: Ensure that the

appliance is switched o before

replacing the lamp to avoid the

possibility of electric shock.

Do not use harsh abrasive

cleaners or sharp metal scrapers

to clean the appliance door glass

since they can scratch the

surface, which may result in

shattering of the glass.

Remove all accessories before

running the pyrolytic function

(also the lateral grids).

Wear protective gloves for

cleaning and maintenance.

The appliance must be

disconnected from the power

supply before any maintenance

operation.

Ensure the appliance is cooled

down before carrying out any

cleaning or maintenance

operation.

If the oven is installed below a

hob, make sure that all burners

or electric hotplates are

switched o during the

selfcleaning (pyrolytic) function.

1 2 3 4 5 6 7 8 9 10 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare