Bauknecht GCX 4862 Bedienungsanleitung PDF herunterladen (Seite 60)

Improper connection of the equipmentgrounding conductor can result in the risk of an electric

shock. Check with a qualified electrician or service representative if you are in doubt whether

the appliance is properly grounded. Do not modify the plug provided with the appliance; If it is

not fit for the outlet. Have a proper outlet installed by a qualified electrician.

Water Connection

Connect the cold water supply hose to a threaded 3/4(inch) connector

and make sure that it is fastened tightly in place. If the water pipes are

new or have not been used for an extended period of time, let the

water run to make sure that the water is clear. This precaution is

needed to avoid the risk of the water inlet to be blocked and damage

the appliance.

Please close the hydrant after using.

Positioning the Appliance

Position the appliance in the desired location. The back should rest against the wall behind it, and the

sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses

that can be positioned either to the right or the left sides to facilitate proper installation.

How to Drain Excess Water From Hoses

If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink.

It will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside

and lower than the sink.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.

Ensure that the water inlet hose is not kinked or squashed.

Extension Hose

If you need a drain hose extension, make sure to use a similar drain hose.

It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.

Syphon Connection

Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink,

making sure to avoid bending or crimping it. The top of the hose must be less than 1000mm.

Start of Dishwasher

The following things should be checked before starting the dishwasher.

1 The dishwasher is level and fixed properly

2 The inlet valve is open

3 There is a leakage at the connections of the conducts

4 The wires are tightly connected

5 The power is switched on

6 The inlet and drain hoses are knotted

7 All packing materials and printings should be taken out from the dishwasher

Attention: After installation, please make sure to keep this manual. The content of this manual is very

helpful to the users.

WARNING:

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 131 132

Keine Kommentare

Bauknecht GCX 4862 Bedienungsanleitung Seite 60