Bauknecht TK Platinum 1083 I Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 31)

QUESTION ANSWER

I changed the router, what do I

have to do?

You can either maintain the same setup properties (network name

and password) or erase the previous setup from the appliance (reset

process) and carry out the setup process again (see "Live-Remote

Control/Setup procedure").

I changed my home network

setup, what do I have to do?

You have to erase the previous setup from the appliance (reset process)

and carry out the setup process again (see "Live-Remote Control/Setup

procedure").

What happens in case of a power

cut?

When the power returns, the Remote Control will be deactivated.

• If the dryer is in "Finish in" mode, the delay countdown continues

automatically and the drying phase starts as planned.

• If the dryer was running, once the power returns the dryer resumes

where it left o. There is no need to press START again even if the

Remote Control is deactivated.

What can I do if the Connection

Status indicator continues to

blink slowly and never lits solidly

on?

If the Connection Status indicator does not lit up solidly, the dryer

has ben successfully connected to the router, but it is not able to

connect to the Internet.

In order to get the appliance connected to the Internet, you have to

check the router and/or the bearer settings.

Correct router settings: NAT must be on; Firewall and DHCP must be

properly set. Password cryptography supported: WEP, WPA, WPA2.

Please refer to the router manual.

Bearer settings: if your Internet service provider has established the

numbers of MAC addresses able to connect to the Internet, you may

not be able to connect the dryer to the cloud. The MAC address is the

unique identier of a device, e.g. the one of your computer. Please

ask your Internet service provider about the procedures to connect a

new device other than a computer (e.g. a dryer) to the Internet.

Where do I nd the MAC address

of the dryer?

Select the Live menu from the Setting menu using the UP and DOWN

key and press the OK key. Select the MAC item from the Live menu

using the UP and DOWN key and press the OK key. The MAC address

is made by a combination of numbers and letters.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Bauknecht TK Platinum 1083 I Gebrauchs- und Pflegeanleitung Seite 31

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Wäschetrockner Bauknecht TK Platinum 1083 I