Bauknecht TK Platinum 1083 I Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 16)

16

selectable for your programme are indicated

on the display.

Press the UP or DOWN key to navigate

through the list of available options. The

selected option blinks. To conrm selection,

press the Ok key. The corresponding symbol

over the display lights up.

Some options / functions can be selected by

directly pressing the button.

Refer to section OPTIONS, FUNCTIONS

AND INDICATORS for more information.

5. START PROGRAMME

Press and hold Start/Pause « until the button

lights up solidly and the display indicates that

the programme starts.

The duration can be recalculated and

adapted in the course of the programme.

During such phases, an animation occurs on

the control panel.

6. CHANGE THE SETTINGS OF A

RUNNING PROGRAMME, IF NEEDED

You can still change some settings after a

programme was started:

• Adjust drying time (only if programme

Drying time or Airing is selected)

• Adjust or cancel Finish in, if a delay was

selected and started

• Add or cancel an option, provided the

progress of the programme still allows it.

Press the relevant button. The selected

setting will blink for a few seconds.

While blinking, you can adjust the setting by

pressing the UP or DOWN key. If the value or

setting stopped blinking, press the button

again.

After a setting has been changed, the

programme continues automatically.

To change the settings of a running

programme or delay, you can also:

• press Start/Pause to put the running

programme on pause

• change your settings

• press Start/Pause again to continue the

programme.

7. CANCEL A RUNNING PROGRAMME, IF

NEEDED

Press and hold the On/O button « until the

display indicates that the programme is

cancelled.

WARNING

After cancelling a running programme,

quickly remove all items and spread

them out so that the heat is dissipated.

8. SWITCH OFF THE DRYER AFTER

PROGRAMME END

The display indicates that the cycle has

nished. Press On/O button « to switch o

the dryer. Open the door and take out your

laundry.

The dryer switches o automatically in about

a quarter of an hour after programme end, to

save energy.

If not switched o right after programme

end, the dryer will tumble the laundry for

about 10 minutes, to prevent creasing. The

display shows an animation.

9. EMPTY WATER TANK / CLEAN DOOR

FILTER / CLEAN BOTTOM FILTER

Empty

• the water tank after each programme

Clean

• the door lter after each programme

• the bottom lter after every fth

programme.

Refer to section CARE AND MAINTENANCE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare