Bauknecht WA 43510 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 19)

37

For models with no fault display,

the washing machine stops in the

appropriate programme step.

First switch the washing machine

off and on again to continue

with the programme.

If the fault persists, please contact

After Sales Service (see “After

Sales Service”).

d.

“Water Stop” fault

(if

fitted)

The “Water Stop” fault may have

been triggered by:

1.

Excess foaming.

2.

A leak in the washing machine.

In this case the pump is switched

on automatically in order to

pump the water out.

For models with a fault display,

the “Water Stop” display lights

up, an acoustic signal sounds and

the spin speed indicator lights

flash. If a digital display is fitted,

“A

” and “F” are also displayed

alternately.

For models with no fault display,

the washing machine stops in the

appropriate programme step.

Switch the appliance off, pull out

the mains plug and turn the

water tap off.

Tilt the appliance forwards

carefully to allow the collected

water to flow out from the

bottom of the appliance.

Then:

1.

Plug in the appliance.

2.

Turn the water tap on (if water

immediately flows into the

appliance again, without the

appliance being started, there is

a fault. Turn off the tap and

notify After Sales Service).

3.

For models with fault display,

select and start the desired

programme again.

For models with no fault

display, continue the

programme by pressing the

“On/Off” button again.

If the fault occurs again, please

contact After Sales Service (see

“After Sales Service”).

“Water Stop” fault, when

the programme selector is

in the “ “position.

The pump is switched on

automatically in order to pump

the water out.

For models with fault display the

washing machine will also detect

a Water Stop fault (leak) if the

programme selector is in the

“ “position. In this case an

acoustic signal sounds and the

digital display (if fitted) displays

“A

” and “F” alternately.

For models with no fault display,

the “Water Stop” fault is

detected when the appliance is

switched on again.

Pull the mains plug out and

ensure that the water tap is

turned off.

Tilt the appliance forwards

carefully to allow the collected

water to flow out.

Then:

1.

Plug in the appliance.

2.

Turn the water tap on (if water

immediately flows into the

appliance again, without the

appliance being started, there

is a fault. Turn the tap off and

notify After Sales Service).

1 2 ... 14 15 16 17 18 19 20 21 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare