Water hardness should be set before
the first wash or if water hardness has
been changed
1
Visual indicator
(depending
on the model).
Unscrew cap.
(depending on the model)
The salt level indicator lamp may remain lit at
the end of several wash cycles. If the water
hardness set to level 1 (soft), no salt is required
and salt indicator lamp will remain off..
Salt indicator on the control panel Salt indicator on the salt reservoir cap
The indicator lamp lights up when
SALT NEEDS TO BE ADDED.
green: OK.
clear: NEEDS TO
BE ADDED
Daily check
Filling the salt reservoir - Dissolve limescale (not necessary if water hardness level is set to “soft 1”!)
- Press and hold together and buttons for minimum 3 seconds.
- The current water hardness setting will be visible on the display.
- Press the button to increase setting. Value range goes from 1 to 7 (when the level reaches 7, the next press of the
start button will set the level back to 1).
- Wait 30 seconds (control panel switches off) or press button to save setting.
Add salt (never add detergent!)
min. 0.8 kg / max. 1 kg
Screw on the cap.
Salt residual
around the cap
need to be
removed. Some
salt reservoir have
a level indicator
integrated in the
cap (see below
how to check).
Once regeneration salt is added, immediately start a wash program (the “Pre-wash” program alone is not sufficient).
Residual saline solution or grains of salt can lead to deep-down corrosion, irreparably damaging the stainless steel components.
The guarantee is not applicable if faults are caused by such circumstances.
1. Ask your water supply company what the water hardness is... 2. ...enter this value on
your dishwasher
SALT
required
German
degrees °dH
French
degrees °fH
English
degrees °eH
Water hardness
level
Insert value is shown
in the display
0 - 5 0 - 9 0 - 6.3 Soft 1 NO
6 - 10 10 - 18 7 - 12.6 Medium 2
YES
11 - 15 19 - 27 13.3 - 18.9 Average 3
16 - 21 28 - 37 19.6 - 25.9 Medium-hard 4
22 - 28 38 - 50 26.6 - 35 Hard 5
29 - 35 51 - 63 35.7 - 44.1 Very hard 6
36 - 50 64 - 90 44.8 - 62.4 Extremely hard 7
Water hardness level is
factory set for medium-
hard water (level 4).
Detergents
When you use Powder or
Gel you must use salt and
set up water hardness level
as indicated in the table on
the right.
Also when you use
Tablets which include salt
functionality you must still
add regeneration salt.
Fill the salt reservoir with water
before the first wash only.
(8 Seiten)
(8 Seiten)
(12 Seiten)
(8 Seiten)
(8 Seiten)
(132 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern