Bauknecht BSIO 3O35 PFE X Betriebsanweisung PDF herunterladen (Seite 4)

OPTIONS AND FUNCTIONS

OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL).

If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED ashes rapidly 3 times

and beeps will sound. The option will not be enabled.

MULTIZONE

If there are not many dishes to be washed, a half loading may

be used in order to save water, electricity and detergent.

Select the program and then press the MULTIZONE button:

the indicator over the button lights up and the symbol of

the chosen rack will appear on the display.

By default the appliance washes dishes in all racks.

To wash only the specic rack, press this button repeatedly:

shown on the display (only lower rack)

shown on the display (only upper rack)

shown on the display (only cutlery rack)

shown on the display (option is OFF and the appliance will

wash dishes in all racks).

Remember to load the upper or lower rack only, and to

reduce the amount of detergent accordingly.

TABLET (Tab)

This setting allows you to optimize the performance of the

program according to the type of detergent used.

Press the START/PAUSE button for 3 seconds (the correspon-

ding symbol will light up) if you use combined detergents in

tablet form (rinse aid, salt and detergent in 1 dose).

If you use powder or liquid detergent, this option should

be o.

POWER CLEAN®

Thanks to the additional power jets this option provides

a more intensive and powerful wash in the lower rack, in the

specic area. This option is recommended for washing pots

and casseroles. Press this button to activate POWER CLEAN

(the indicator lights up).

OPERATION INDICATOR

A LED light projected on the oor indicates that the dis-

hwasher is working. One of the following operating modes

can be selected:

a) Disabled function.

b) When the cycle starts the light goes on for few seconds,

stays o during the cycle and ashes at the end of the cycle.

c) The light stays on during the cycle and ashes at the end of

the cycle (default mode).

If the delayed start was set, the light goes on either for the rst

few seconds or the entire duration of the countdown, based on

whether mode b) or c) was set.

The light goes o every time the door is opened. To select the

mode you prefer, switch on the machine, hold down button P

until one of the three letters appears on the

display, press button P until you reach the desired letter (or

mode), hold down button P to conrm the selection.

Note: If ActivEco is active and it opens the door, then

OPERATION INDICATOR will not ash at the end of cycle.

DELAY

The start time of the program may be delayed for a period of

time between 1 and 12 hours.

1. Press the DELAY button: the corresponding «h» symbol

appears on the display; each time you press the button,

the time (1h, 2h, etc. up to max. 12h) from the start of the

selected wash cycle will be increased.

2. Select the wash program, press the START/PAUSE button

and within 4 seconds close the door: the timer will begin

counting down.

3. Once this time has elapsed, the indicator light «h» switches

o and the wash cycle begins.

To adjust the delay time and select a shorter period of

time, press the DELAY button. To cancel it, press the button

repeatedly until the selected delayed start indicator light «h»

switches o.

The DELAY function cannot be set once a wash cycle has

been started.

EXTRA DRY

To improve the drying of the dishes, after selecting the

program, press the EXTRA DRY button and the indicator light

comes on.

A higher temperature during the nal rinse and an extended

drying phase allow for improving drying. To deselect the

option, press the same button again. The EXTRA DRY option

results in the lengthening of the wash cycle.

ActivEco

ActivEco is a convection drying system which automatically opens the

door during/after drying phase to ensure exceptional drying perfor-

mance every day. Door opens at the temperature that is safe to your

kitchen furniture, thus door will not be opened when the option of

SANI RINSE or TURBO are on.

As additional steam protection, special designed protection foil is ad-

ded together with the dishwasher. To see how to mount protection foil

please refer to (INSTALLATION GUIDE).

ActivEco functionality could be disabled by the user as follows:

1. Go to the Dishwasher software menu pressing

and holding P button (6 sec).

2. You are currently in Light Control Menu (please refer to OPERATION

INDICATOR description), if you don’t want to change anything please

press and hold P button (3 sec).

3. You switched to ActivEco Control Menu, you could change

status of ActivEco functionality by pressing P button:

E – enabled d – disabled

To conrm the change and exit from the Control Menu please press

and hold P button (3 sec).

1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare

Bauknecht BSIO 3O35 PFE X Betriebsanweisung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Bauknecht BSIO 3O35 PFE X