Bauknecht DBIBS 93 LB X Bedienungsanleitung PDF herunterladen (Seite 7)

GB7

Before calling the After-Sales Service:

1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide".

2. Switch the appliance off and back on again it to see if the fault persists.

If after the above checks the fault still occurs, get in touch with the nearest After-Sales Service.

Always specify:

• A brief description of the fault;

• The exact type and model of the appliance;

• The service number (number after the word "Service" on the rating plate), located on the inside of the appliance. The service number is also indicated on

the guarantee booklet;

• Your full address;

• Your telephone number.

If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out

correctly).

The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights.

Models with Soft Button panel + Silent Speed

T1. Button ON/OFF suction motor

T2. Selection button operating suction speed (power)

Note: The intensive suction speed (power) (LED L3 flashing) lasts for approximately 5 minutes, then the medium suction speed (power) is automatically set

(LED L2 on)

T3. Button ON/OFF lighting

T4. Selection button ‘silent’ suction speed (power)

L1. LED medium suction speed (power)

L2. LED high suction speed (power)

L3 LED intensive suction speed (power) - timed (5 min.).

L4 LED filter saturation:

flashing: carry out maintenance of the charcoal filter;

on: carry out maintenance of grease filters.

L5 LED low (silent) suction speed (power)

L1+L2+L3 flashing in sequence: automatic operation at high temperature (see related section)

Reset filter saturation

After carrying out filter maintenance, press and hold button T1, LED L4 switches off.

Activation of the LED for charcoal filter saturation

The LED for charcoal filter saturation is normally disabled. To activate it, proceed as follows:

With the hood off, press and hold for a long time and simultaneously T1 and T4: L1 flashes first then L2 as well, to indicate successful activation.

Disabling the LED for charcoal filter saturation: repeat the above operation, L1 and L2 start flashing first, then only L1, to indicate successful disabling.

Automatic operation at high temperature

The hood is fitted with a sensor that detects the temperature. When this becomes too high, the sensor automatically activates the medium suction speed

(power). The hood switches off when the temperature detected by the sensor has lowered significantly.

CONTROLS

T1 T2 T3 T4

L1 L2 L3 L4 L5

AFTER-SALES SERVICE