Bauknecht DST 6460 ES Bedienungsanleitung PDF herunterladen (Seite 21)

GB19

4. ON/OFF light key

Press the key to gradually switch the lights on/off varying their intensity.

5. Grease filter alarm reset key

After 80 hours of operation, the ON key comes on to indicate that the grease filter needs cleaning.

Once the grease filter has been cleaned press “5” for at least 3 seconds while the hood is ON, and operating at any speed.

6. “6th Sense” key /“Air Quality Control” (Automatic Operation)

IMPORTANT: this function does not activate if the hood is OFF.

With Automatic operation the hood can operate in two different modes. To set either mode keep pressing key “6” until the desired mode is activated. The “6th

Sense” mode (key “6” comes on), ensures correct suction of cooking steams based on the environmental conditions detected.

During cooking the system promptly reacts to any Steam/Gas increase, and remains at the set speed for at least 1 minute before returning to the lower speed or

switching off.

At the end of cooking, when the environmental conditions have returned to those before cooking, the system switches off: However, if the conditions are similar

to the stand-by parameters, the hood will be switched off 30 minutes after, even if the stand-by parameters have not actually been reached.

The “Air Quality Control” mode (“LD5” comes on) uses the hood as an air monitoring system, ensuring a high air quality level.

The system promptly reacts to any Steam/Gas increase, and remains at the set speed for at least 1 minute before returning to the lower speed, or switching off.

After the effect of the gas is terminated, when the environmental conditions have returned to those before cooking, the system switches off:

Note: Each time the hood goes from OFF to Stand-by mode, the system enters “6th Sense” mode.

To exit Automatic Operation press keys “2” or “3” (the “LD5” led or the “6” key go off), decreasing or increasing the automatic speed by one step, or press “1” to

return to Stand-By mode.

7. Carbon filter alarm reset key

After 320 hours of operation, with the hood ON, the carbon filter alarm reset key comes on to indicate that the carbon filter needs cleaning.

Once the carbon filter has been cleaned press “7” for at least 3 seconds while the hood is ON, operating at any speed, to reset the filter alarm.

Automatic sensor calibration

The system requires automatic sensor calibration. This calibration is performed, with the motor off, during first installation, as well as each time power supply is

cut off.

This operation is confirmed by key “6” flashing and key “1” coming on.

Manual sensor calibration

The system can also be manually forced to perform the calibration procedure as follows:

Place the hood in Stand-by and press “6” for 5 seconds.

This operation is confirmed by key “6” flashing and key “1” coming on.

This operation should be performed when:

• the hood is installed for the first time;

• there is a power cut lasting several hours or days;

• a very quick temperature change occurs in the kitchen.

Sensor test

The sensor test is performed continually during automatic operation.

In case of fault, keys “1” and “6” flash (contact customer service). In this case it will still be possible to use the hood in manual mode.

Note: to optimise sensor performance:

• always keep the sensor area clean and free from any obstructions that may prevent air from reaching the sensor element;

• ensure that no water (or other liquid) sprays reach the sensor;

• avoid contact of the sensor with organic solvents, silicon resins and ammonia.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

Kommentare zu diesen Handbüchern

Keine Kommentare

Bauknecht DST 6460 ES Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hauben Bauknecht DST 6460 ES