Bauknecht DTLG 9010 Bedienungsanleitung PDF herunterladen (Seite 16)

GB16

- Use protective gloves.

- Disconnect the appliance from the power supply.

IMPORTANT: After carrying out hood or filter cleaning, refit the front panel and filters, checking correct installation and hooking, otherwise

the hood will not switch on.

GREASE FILTER

Its purpose is to retain the particles of grease produced by cooking.

It must be cleaned once a month (or when the filter saturation warning system indicates this need) with

non-aggressive detergents, by hand or in a dishwasher at low temperature and with short cycle.

Cleaning in a dishwasher may cause discolouring of the metallic grease filter, but its filtering efficiency is

unaffected.

Grease and carbon filters must be fitted and removed while the air intake panel of the hood is open. To

carry out this procedure, press ON (T5). Remove the front panel by pulling the top part of each side at the

same time. The panel will flip forwards, providing access to the grease filters (Figure 5).

ACTIVATED CARBON FILTER (Filter Version only)

Its purpose is to retain the unpleasant odours produced by cooking.

The carbon filter becomes saturated after more or less prolonged use depending on the type of cooker and

how often the grease filter is cleaned. In any case the carbon filter must be replaced at least every four

months.

The carbon filter CANNOT be washed or regenerated.

The carbon filters can be inserted after removing the grease filters. (Figure 6)

LIGHTING SYSTEM

Disconnect the appliance from the power supply.

IMPORTANT:

Do not touch the neon with bare hands after prolonged hood use with the lights switched on.

To replace the neon, proceed as follows (Figure 7):

1. Lift the extraction panel.

2. Disconnect the power supply (this operation can be carried out by pulling out the plug, if accessible, or

opening the switch, if provided for during installation, or pressing the red reset button in the control

box).

3. Remove the screws fixing the upper front.

4. Lift the upper front

5. Remove the burnt-out neon and replace it with one having the same characteristics (Model T5 14W

860).

If the lighting does not work, make sure the neon is properly fitted before calling the After-Sales Service.

WARNING

MAINTENANCE

Fig. 5

Fig. 6

Fig. 7

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Keine Kommentare

Bauknecht DTLG 9010 Bedienungsanleitung Seite 16