Bauknecht WATK Prime 9716 Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 30)

TROUBLESHOOTING

The washer dryer may sometimes not work properly for certain reasons. Before calling the Support

Centre, it is recommended to check to see if the problem can be easily resolved using the following list.

Anomalies: Possible causes / Solution:

The washer dryer does not

turn on.

• Theplugisnotinsertedintotheelectricaloutlet,ornot

enough to make contact.

• Therehasbeenapowerfailure.

• Thedoorisnotfullyclosed.

The wash cycle does not start. • TheON/OFFbuttonhasnotbeenpressed.

• TheSTART/PAUSEbuttonhasnotbeenpressed.

• Thewatertapisnotopen.

• Astartdelayhasbeenset.

The washer dryer does not

ll with water (the message

“H2O” is shown on the

display).

• Thewaterintakehoseisnotconnectedtothetap.

• Thehoseisbent.

• Thewatertapisnotopen.

• Themainswatersupplyhasbeenshuto.

• Thereisnotenoughpressure.

The washer dryer loads and

drains water continuously.

• TheSTART/PAUSEbuttonhasnotbeenpressed.

• Thedrainhosehasnotbeeninstalledat65to100cmfrom

the ground.

• Theendofthedrainhoseisimmersedinwater.

• Thedrainconnectoronthewalldoesnothaveanairvent.

If the problem persists after having performed these

checks, close the water tap, shut o the washer dryer, and

call the Support Centre.If the dwelling is located on one

of the uppermost oors of a building, a siphon eect can

sometimes occur, thus causing the washer dryer to load

and drain water continuously.Special anti-siphon valves are

available on the market to prevent these types of problems.

The washer dryer does not

drain or does not spin.

• Theprogrammedoesnotincludethedrainingfunction:with

certain programmes it must be activated manually.

• Thedrainhoseisbent.

• Thedrainlineisobstructed.

The washer dryer vibrates

excessively during the spin

cycle.

• Atthetimeofinstallation,thedrumwasnotproperly

unlocked.

• Thewasherdryerisnotlevel.

• Thewasherdryerissqueezedbetweenfurnitureandthewall.

The washer dryer leaks water. • Thewaterintakehosehasnotbeentightenedproperly.

• Thedetergentdispenserisclogged.

• Thedrainhosehasnotbeenproperlyfastened.

The indicator lights for the

“15° Green & Clean” option

and the START/PAUSE button

ash quickly and the display

shows an error code (e.g.:

F-01, F-..).

• Shutothemachine,disconnecttheplugfromtheoutlet,

and weight about 1 minute before turning it back on.

If the problem persists, call the Support Centre.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 38 39

Kommentare zu diesen Handbüchern

Keine Kommentare

Bauknecht WATK Prime 9716 Gebrauchs- und Pflegeanleitung Seite 30

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waschmaschinen Bauknecht WATK Prime 9716