Bauknecht WATK Prime 8612 Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 7)

EN

7

Socket outlet / plug (valid for

both countries)

If the tted plug is not suitable

for your socket outlet, contact

Customer Support for further

instruction. Do not replace the

plug on your own.This

operation must only be carried

out by a qualied technician, in

compliance with the

manufacturer's instructions

and the current safety

regulations.

CORRECT USE

Do not exceed the maximum

load allowed. Check the

maximum load allowed in the

programme chart.

Close the water tap when the

washer dryer is not in use.

Do not use any solvents (e.g.

turpentine, benzene),

detergents containing

solvents, scouring powder,

glass or general purpose

cleaners, and ammable uids;

do not wash fabrics treated

with solvents or ammable

liquids in the washer dryer.

Do not over-dry the laundry.

Fabric softeners, or similar

products, should be used as

specied by the fabric softener

instructions.

Do not dry unwashed laundry.

CLEANING AND

MAINTENANCE

The appliance must be

disconnected from the power

supply before carrying out any

cleaning or maintenance

operation.

Never use steam cleaning

equipment.

corresponds to that of your

home.

For installation to comply with

current safety regulations, an

omnipolar switch with

minimum contact gap of 3mm

is required.

Regulation require that the

appliance is earthed.

For appliances with tted plug,

if the plug is not suitable for

your socket outlet, contact a

qualied technician.

Do not use extension leads,

multiple sockets or adapters.

Do not connect the appliance

to a socket which can be

operated by remote control.

The power cable must be long

enough for connecting the

appliance, once tted in its

housing, to the main power

supply.

Do not pull the power supply

cable.

If the power cable is damaged

it must be replaced with an

identical one. The power cable

must only be replaced by a

qualied technician in

compliance with the

manufacturer instruction and

current safety regulations.

Contact an authorised service

centre.

Do not operate this appliance

if it has a damaged mains cord

or plug, if it is not working

properly, or if it has been

damaged or dropped. Do not

immerse the mains cord or

plug in water. Keep the cord

away from hot surfaces.

The electrical components

must not be accessible to the

user after installation.

Do not touch the appliance

with any wet part of the body

and do not operate it when

barefoot.

ELECTRICAL CONNECTIONS

FOR GREAT BRITAIN AND

IRELAND ONLY

Fuse replacement

If the mains lead of this

appliance is tted with a BS

1363A 13amp fused plug, to

change a fuse in this type of

plug use an A .S .T .A .

approved fuse to BS 1362 type

and proceed as follows:

1. Remove the fuse cover (A)

and the fuse (B).

2. Insert the 13A replacement

fuse inside the cover.

3. Insert both into the plug.

Important:

The cover must be re-installed

after having replaced the

fuse;if lost, the plug cannot be

used and must be replaced.

Correct replacement are

identied by the colour insert

or the colour embossed in

words on the base of the plug.

Replacement fuse covers are

available from your local

electrical store.

For the Republic of Ireland

only

The information given in

respect of Great Britain will

frequently apply, but a third

type of plug and socket is also

used, the 2-pin, side earth

type.

1 2 3 4 5 6 7 8 9 10 11 12 ... 38 39

Kommentare zu diesen Handbüchern

Keine Kommentare