Bauknecht TK Platinum 1083 I Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 18)

18

Press the UP or DOWN key to set the

desired delay of the programme end.

Press Start / Pause - the countdown of

the delay starts. The display indicates

the default programme duration

of the selected programme, and

underneath the set “Finish in” period.

The Start/Pause button and the Finish

in button light up; the colon between

hours and minutes of the Finish in

period blinks.

The programme starts automatically,

in time to be nished at the end of the

delay period.

The programme duration can be

inuenced by certain factors, mainly

by the humidity level of the laundry.

For that reason, the programme

duration is recalculated and adapted

in certain programme phases.

During these phases, the display

shows an animation. This can lead

to an earlier or later programme end

than originally set with the Finish

in function. In that case, the display

indicates, after programme end, that

the programme has nished earlier or

later.

The maximum selectable delay is

23:30 hours. To exit the settings mode

without setting a Finish in period,

select “__:__”.

To cancel the delay:

Either press Start/Pause to cancel

the delay. To start the selected

programme immediately, press Start/

Pause again.

Or press and hold On/O to cancel the

complete programme setting.

SETTINGS The following settings can be

changed:

Language: to adapt the display

language

Key tones: to adapt the tone when

pressing a button

Cycle end alert: to adjust the tone

signal at the end of the programme or

switch it o completely

Display contrast: to regulate the

contrast of the display text

Water conductivity: to adapt to

your local water conductivity; refer

to section FIRST TIME USE for more

information.

Remember last used cycle: to activate

or deactivate recall of the programme

which you used last when switching

on the dryer

Eco mode: to activate or deactivate

the automatic switch-o function

after programme end

Factory settings: to return to factory

settings

Live menu: remote control settings

Press and hold the Settings button

for at least 3 seconds . The display

indicates that you entered the

Settings mode.

Press the UP or DOWN key to navigate

through the settings. Conrm the

setting which you want to change by

pressing the OK key.

Press the UP or DOWN key to adjust

the setting, and afterwards press the

OK key to conrm.

Press the Settings button to exit. If

you do not press the Settings button,

the settings mode will be exited

automatically after about 10 seconds.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 44 45

Kommentare zu diesen Handbüchern

Keine Kommentare