Bauknecht TK Premium 95A2 I Gebrauchs- und Pflegeanleitung PDF herunterladen (Seite 7)

7

EN

colour embossed in words on

the base of the plug.

Replacement fuse covers are

available from your local elec-

trical store.

For the Republic of Ireland

only

The information given in

respect of Great Britain will fre-

quently apply, but a third type

of plug and socket is also used,

the 2-pin, side earth type.

Socket outlet / plug (valid for

both countries)

If the tted plug is not suitable

for your socket outlet, please

contact After-sales Service for

further instruction. Please do

not attempt to change plug

yourself. This procedure needs

to be carried out by a qualied

technician in compliance with

the manufactures instructions

and current standard safety

regulations.

CORRECT USE

Do not exceed the maximum

load allowed. Check the maxi-

mum load allowed in the pro-

gramme chart.

Do not dry unwashed items in

the tumble dryer.

Do not overdry the laundry.

Take care that no lint or dust is

accumulated around the dryer.

Fabric softeners, or similar

products, should be used as

specied by the fabric softener

instructions.

Do not operate this dryer if it

has a damaged mains cord or

plug, if it is not working prop-

erly, or if it has been damaged

or dropped. Do not immerse

the mains cord or plug in wa-

ter. Keep the cord away from

hot surfaces

The electrical components

must not be accessible to the

user after installation.

Do not touch the dryer with

any wet part of the body and

do not operate it when bare-

foot.

ELECTRICAL CONNECTION

FOR GREAT BRITAIN AND

IRELAND ONLY

Fuse replacement.

If the mains lead of this dryer is

tted with a BS 1363A 13amp

fused plug, to change a fuse in

this type of plug use an A.S.T.A.

approved fuse to BS 1362 type

and proceed as follows:

1. Remove the fuse cover (A)

and fuse(B).

2. Fit replacement 13A fuse into

fuse cover.

3. Ret both into plug.

Important:

The fuse cover must be retted

when changing a fuse and if

the fuse cover is lost the plug

must not be used until a cor-

rect replacement is tted.

Correct replacement are identi-

ed by the colour insert or the

The dryer is not designed for

built-in installation.

The dryer can be installed un-

der a worktop, provided that

adequate ventilation of the

dryer is assured. Install a ven-

tilation grid (minimum 45 cm

x 8 cm), in the rear part of the

worktop under which the dryer

is installed.

ELECTRICAL WARNINGS

Make sure the voltage speci-

ed on the rating plate corre-

sponds to that of your home.

For installation to comply with

current safety regulations, an

omnipolar switch with mini-

mum contact gap of 3mm is

required.

Regulation require that the

dryer is earthed.

For dryers with tted plug, if

the plug is not suitable for you

socket outlet, contact a quali-

ed technician.

Do not use extension leads,

multiple sockets or adapters.

Do not connect the dryer to a

socket which can be operated

by remote control.

The power cable must be long

enough for connecting the

dryer, once tted in its hous-

ing, to the main power supply.

Do not pull the power supply

cable.

If the power cable is damaged

it must be replaced with an

identical one. The power cable

must only be replaced by a

qualied technician in compli-

ance with the manufacturer

instruction and current safety

regulations. Contact an author-

ized service centre.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare