EN -1-
Chart
(see at right for options description)
PROGRAM SELECTION
BUTTON
Push “P” button (repeatedly)
until selected program number
is shown on the display
(P1...Px) - see “Table of
programs” below.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the program.
When the door is opened during a washing cycle, the
cycle is temporarily paused: the Start indicator blinks.
To resume the cycle push Start button and close
the door within 3 seconds.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels
the program ongoing draining water for 1 minute
(0:01 is shown into the display). If pressed when
the dishwasher is switched off, it drains any
possible liquids from dishwasher (1 minute
process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard
loading comparison test and other tests, contact the following address: “
[email protected]”.
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.
* Power consumption in: Left-on mode: 0.70 W / Off-mode: 0.40 W.
Table of programs
Deter-
gent
Consumption
Drying
phase
Programs
Available
options
Loading instructions
Litres kWh
Minutes
1)
P1
Sensor Power
Clean Plus
40-70°C
Delay
Antibacterial
rinse
Power Clean
Use for normal soiled dishes with
dried-on food. Senses the level of
soiling on the dishes and adjusts the
program accordingly. When the
sensor is detecting the soil level an
animation appears in the display and
the cycle duration is updated.
The Power Clean option is activated
automatically with this program.
To deactivate, press the Power Clean
button on the control panel.
X 7-15 1.00-1.70 70-172 Full
P2
Glass 40°C
Delay
Light soiling, for example glasses and
cups.
X 10.5 0.85 105-114 Light
P3
Express 45°C
Delay
Lightly soiled crockery, with no
dried-on food.
X 11.0 0.85 30-50 NO
P4
Eco
2)
50°C
Delay
Antibacterial
rinse
Power Clean
Normally soiled crockery.
Standard Program the most efficient
in terms of its combined energy and
water consumption.
X 11.0 0.92 240 Full
P5
Normal 60°C
Delay
Antibacterial
rinse
Normally soiled crockery. X 11.0 1.30 80-95 Full
P6
Night 39 dBA 50°C
Delay
Normally soiled crockery, gentle and
quiet thanks to the lower spray
pressure (39 dbA).
X 14.0 1.20 290-299 Light
5019 400 00260
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING
THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER
30 SECONDS IF NO CYCLE HAS STARTED.
POWER CLEAN PLUS
Thanks to the additional power jets
this option provides a more
intensive and powerful wash in the
lower rack, in the specific area.
This option is recommended for
washing pots and casseroles
(see page 4). Press this button
to activate Power Clean (the
indicator lights up).
For non Power Clean loading
to achieve best cleaning
performances and resources
optimization, Power Clean should
be switched off.
ANTIBACTERIAL RINSE
2
)
This function activates an antibacterial
rinse at the end of the wash cycle,
guaranteeing a further reduction of
bacteria. Press the button to activate or
deactivate the function.
This function can be used with the
programs indicated in the table of
programs. The dishwasher door must be
kept shut for the entire duration of the
program in order to guarantee reduction
of bacteria. If the door is opened the
indicator lamp starts flashing.
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds
(until the indicator lights
up) if you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose).
If you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press
of the button, the
delayed start indicator
increases by one hour
and after 24 restarts
from 0.
Then press the START
button. The dishwasher
will start after the set
time.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
RINSE AID
INDICATOR
When lit (at the end of
the cycle), the rinse aid
dispenser needs to be
refilled.
SALT INDICATOR
When lit (at the end
of the cycle), the salt
reservoir needs to be
refilled.
OPERATION
INDICATOR
A LED light projected
on the floor indicates
that the dishwasher is
working.
Quick reference guide
Bauknecht is a registered trademark
(8 Seiten)
(12 Seiten)
(8 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern