Bauknecht GSXK 8214A2 Bedienungsanleitung PDF herunterladen

EN -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the program.

When the door is opened during a washing cycle, the

cycle is temporarily paused: the Start indicator blinks.

To resume the cycle push Start button and close

the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on

conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “contact_bk@bauknecht.com”.

* Power consumption in: Left-on mode: 1.08 W / Off-mode: 0.40 W.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor

PowerClean

Plus

40-70°C

Delay

PowerClean

Antibacterial

rinse

Use for normal soiled dishes with dried-on

food. Senses the level of soiling on the dishes

and adjusts the program accordingly. When

the sensor is detecting the soil level an

animation appears in the display and the

cycle duration is updated. The PowerClean

option is activated automatically with this

program. To deactivate, press the

PowerClean

button on the control panel.

X 7-15 1.00-1.70 70-172 Full

Glass 40°C

Delay Light soiling, for example glasses and cups. X 10.5 0.85 105-114 Light

Express 45°C

Delay

Lightly soiled crockery, with no dried-on

food.

X 11.0 0.85 30-50 NO

Eco

50°C

Delay

PowerClean

Antibacterial

rinse

Normally soiled crockery.

Standard Program the most efficient in

terms of its combined energy and water

consumption.

X 9.0 0.92 240 Full

Normal 60°C

Delay

Antibacterial

rinse

Normally soiled crockery. X 11.0 1.30 80-95 Full

Night 50°C

Delay

Normally soiled crockery, gentle and quiet

thanks to the lower spray pressure (39 dbA).

X 14.0 1.20 290-299 Light

5019 400 00785

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON. FOR ENERGY SAVING THE

CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER

30 SECONDS IF NO CYCLE HAS STARTED.

POWERCLEAN

Thanks to the additional power

jets this option provides a more

intensive and powerful wash in

the lower rack, in the specific

area. This option is

recommended for washing pots

and casseroles (see page 4).

Press this button to activate

PowerClean

(the indicator

lights up).

For non PowerClean

loading to

achieve best cleaning

performances and resources

optimization, PowerClean

should be switched off.

SALT INDICATOR

When lit (at the end of the cycle), the

salt reservoir needs to be refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle), the

rinse aid dispenser needs to be refilled.

TABLET SETTING

This setting allows to

optimize the cycle

performances according

the type of detergent

used. Push the Tablet

button for 3 seconds (until

the indicator lights up)

if you are using the

combined detergents in

tablet (rinse aid, salt and

detergent in 1 dose).

If you are using powder

detergent or liquid

detergent, the Tablet

indicator on the control

panel has to be off.

DELAYED START

BUTTON

Push the button

(repeatedly) to delay the

start of the program.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed

start indicator increases

by one hour and after

24 restarts from 0.

Then press the START

button. The dishwasher

will start after the set

time.

ANTIBACTERIAL RINSE

This function activates an antibacterial

rinse at the end of the wash cycle,

guaranteeing a further reduction of

bacteria. Press the button to activate or

deactivate the function. This function

can be used with the programs

indicated in the table of programs. The

dishwasher door must be kept shut for

the entire duration of the program in

order to guarantee reduction of

bacteria. If the door is opened the

indicator lamp starts flashing.

OPERATION

INDICATOR

A LED light

projected on the

floor indicates that

the dishwasher is

working.

Quick reference guide

Bauknecht is a registered trademark

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - 5019 400 00785

EN -1-Chart(see at right for options description)PROGRAM SELECTION BUTTONPush “P” button (repeatedly) until selected program number is shown on the di

Seite 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Seite 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Seite 4 - How to use PowerClean

EN -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rack4A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils

Seite 5 - Maintenance and care

EN -5-Switching off the appliance. Everything OK...Wash cycleSelect program678Maintenance and careMaintenance and careOverview of programsThe max. pos

Seite 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Seite 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...salt indicator lit - Use tablets for soft water. - Set “Tablet” option

Seite 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A