Bauknecht GSXK 6214A2 Bedienungsanleitung PDF herunterladen

EN -1-

Bauknecht is a registered trademark

Chart

(see at right for options description)

PROGRAMS SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle push Start button and

close the door within 3 seconds.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on

conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “[email protected]om”.

*Power consumption in Left-on mode: 1.50 W / Off-mode: 0.50 W

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

Sensor 40°-70°C

Delay

1/2 load

PowerClean

Recommended program for routine

washes, with dried-on food.

X 7-15 1.00-1.70 70-172 Full

Pre-Wash cold

Delay Crockery to be washed later. — 4.0 0.01 14-16 NO

Express 45°C

Delay

Lightly soiled crockery, with no dried-

on food.

X 11.0 0.85 30-50 NO

Eco

50°C

Delay

1/2 load

PowerClean

Normally soiled crockery.

Standard program, the most efficient

in terms of its combined energy and

water consumption.

X 10.0 0.922 240 Full

Normal 60°C

Delay

1/2 load

Normally to heavily soiled crockery. X 11.0 1.30 80-95 Full

Steam

Delay

PowerClean

Program including steam action

dedicated for heavily soiled crockery,

pots and pans.

Soaking or hand pretreatment is no

longer needed.

X 14.5 1.75 180-190 Full

4000 107 41770

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

TABLET SETTING

This setting allows to optimize

the cycle performances

according the type of

detergent used.

Push the Tablet button for

3 seconds (until the indicator

lights up) if you are using the

combined detergents in tablet

(rinse aid, salt and detergent in

1 dose). If you are using

powder detergent or gel

detergent, the Tablet indicator

on the control panel has

to be off.

DELAYED START BUTTON

Push the button (repeatedly)

to delay the start of the

program – delay indicator

turns on. Adjustable from

1to 24hours. With each

press of the button, the delay

increases by one hour and

after “h 24” returns to

“h 00”. When this option is

selected the delay indicator

turns on. Then press the

START button. The

dishwasher will start after the

set time.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

POWERCLEAN

Thanks to the additional

power jets this option

provides a more intensive

and powerful wash in the

lower rack, in the specific

area. This option is

recommended for washing

pots and casseroles (see

page 4). Press this button to

activate PowerClean (the

indicator lights up).

1/2 LOAD BUTTON

Half load cycle can be used

for the upper or lower

rack.

Select the required

program then press the

“Half Load” button - the

light comes on.

Turns off at the end of the

program.

The “Half Load” option

can be used with the

programs indicated in the

table of programs.

Reference guide

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - 4000 107 41770

EN -1-Bauknecht is a registered trademarkChart(see at right for options description)PROGRAMS SELECTION BUTTONPush “P” button (repeatedly) until select

Seite 2 - Daily check

EN -2-First time use14109235 7861- salt reservoir2- rinse aid dispenser3- detergent dispenser4- racks system5,6,7,8- available functions on the pan

Seite 3 - Daily use

EN -3-Daily check3Check the rinse aid indicator to check the level into the dispenser.(depending on the model)Rinse aid indicator on the control panel

Seite 4 - How to use PowerClean

EN -4-How to load the racksCLICK!Rotate the flapclockwise andhook on rack4A - Adjustable flaps (2 or 4): in horizontal position for cups/long utensils

Seite 5 - Maintenance and care

EN -5-6512Wash cycleSelect program67Maintenance and careMaintenance and careOverview of programsThe max. possible number of programs is illustrated in

Seite 6 - What to do if

EN -6-What to do if...If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.Most fault

Seite 7

EN -7-What to do if...Crockery and cutlery... Possible causes... Solutions...have deposits: regeneration salt residue - Water too hard. - In areas

Seite 8

EN -8-What to do if...If, after carrying out the above checks, the fault persists, disconnect the mains plug and turn off the water tap. Contact the A