Bauknecht GCI 826 IX Bedienungsanleitung PDF herunterladen (Seite 24)

Care and maintenance

Shutting off the water and electricity supplies

• Turn off the water tap after every wash cycle to avoid leaks.

• Always unplug the appliance when cleaning it and when

performing maintenance work.

Cleaning the dishwasher

• The external surfaces of the machine and the control panel

can be cleaned using a non-abrasive cloth which has been

dampened with water. Do not use solvents or abrasive

products.

• Any marks on the inside of the appliance may be removed

using a cloth dampened with water and a little vinegar.

Preventing unpleasant odours

• Always keep the door of the appliance ajar in order to avoid

moisture from forming and being trapped inside the machine.

• Clean the seals around the door and detergent dispensers

regularly using a damp sponge. This will avoid food becoming

trapped in the seals, which is the main cause behind the

formation of unpleasant odours.

Cleaning the spray arms

Food residue may become encrusted onto the spray arms

and block the holes used to spray the water. It is therefore

recommended that you check the arms from time to time and

clean them with a small non-metallic brush.

The two spray arms may both be removed.

To remove the upper spray arm,

turn the plastic locking ring in an

anti-clockwise direction. The upper

spray arm should be replaced

so that the side with the greater

number of holes is facing upwards.

The lower spray arm can be

removed by pressing on the side

tabs and pulling it upwards.

Cleaning the water inlet hose

If the water hoses are new or have not been used for an extended

period of time, let the water run to make sure it is clear and free

of impurities before performing the necessary connections. If this

precaution is not taken, the water inlet could become blocked

and damage the dishwasher.

Clean the water inlet filter at the tap outlet regularly.

- Turn off the water tap.

- Unscrew the end of the water inlet hose, remove the filter and

clean it carefully under running water.

- Re-place the filter and screw the water hose back into position.

Cleaning the filters

The filter assembly consists of three filters which remove food

residues from the washing water and then recirculate the water.

They must be cleaned if you wish to achieve the best results in

every wash.

Clean the filters regularly.

The dishwasher must not be used without filters or if the filter

is loose.

• After several washes, check the filter assembly and if necessary

clean it thoroughly under running water, using a non-metallic

brush and following the instructions below:

1. Turn the cylindrical filter C in an anti-clockwise direction and

pull it out

(fig. 1).

2. Remove the cup filter B by exerting a slight pressure on the

side flaps

(fig. 2);

3. Slide out the stainless-steel plate filter A.

(fig. 3).

4. Inspect the trap and remove any food residues. NEVER

REMOVE the wash-cycle pump protection

(black detail) (fig.4).

After cleaning the filters, re-place the filter assembly and fix it

in position correctly; this is essential for maintaining the efficient

operation of the dishwasher.

Leaving the machine unused for extended

periods

• Disconnect the appliance from the electricity supply and shut

off the water tap.

• Leave the door of the appliance ajar.

• When you return, run a wash cycle when the dishwasher is

empty.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

Kommentare zu diesen Handbüchern

Keine Kommentare

Bauknecht GCI 826 IX Bedienungsanleitung Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Geschirrspüler Bauknecht GCI 826 IX