Bauknecht KMT 9145 PT Wartungshandbuch PDF herunterladen (Seite 16)

GB40

Below is a list of some possible malfunctions.

If the problem cannot be resolved as described, contact After-sales Service.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE REMEDY

The coffee is not hot. • The cups have not been pre-

heated.

• Heat the cups by rinsing them with hot

water.

• The brewing unit has cooled

down because 2/3 minutes have

elapsed since the last coffee was

made.

• Before making coffee, heat the brewing

unit by selecting the RINSE function

from the menu.

• The set temperature is not high

enough.

• Change the set temperature (see

paragraph Changing the coffee

temperature).

The coffee is not creamy

enough.

• The coffee is ground too coarsely. • Turn the grinding adjustment knob one

click anti-clockwise towards the

number 1 while the coffee mill is in

operation (Figure 14).

• The blend of coffee is unsuitable. • Use a blend of coffee specifically for

espresso coffee machines.

The coffee runs out too slowly

or in drips.

• The coffee is ground too finely. • Turn the grinding adjustment knob one

click clockwise towards the number 7

while the coffee mill is in operation

(Figure 14). Continue one click at a time

until coffee run-off is satisfactory.

Results are only visible after running

off 2 coffees.

The coffee runs out too

quickly.

• The coffee is ground too coarsely. • Turn the grinding adjustment knob one

click anti-clockwise towards the

number 1 while the coffee mill is in

operation (Figure 14). Avoid turning the

grinding coarseness regulator too far

otherwise when you select 2 cups, the

coffee may run out in drips. Results are

only visible after running off 2 coffees.

The coffee does not run out of

one or either of the spouts.

• The spouts are blocked. • Clean the spouts with a toothpick

(Figure 26).

The coffee does not come out

of the spouts, but around the

service door (A2).

• The holes in the spouts are

clogged with dry coffee powder.

• Clean the spouts with a toothpick, a

sponge or a hard bristled kitchen brush

(Figures 26-28).

• The coffee feed (A3) inside the

service door is blocked.

• Clean the coffee feed (A3) thoroughly,

especially around the hinges.

Water comes out of the spouts

instead of coffee.

• Ground coffee is blocking the

funnel (A21)

• Clean the funnel (A21) with a wooden

or plastic fork and clean the inside of

the machine.

The milk does not come out of

the milk spout (C5).

• The intake tube is not inserted or

is inserted incorrectly.

• Insert the intake tube (C4) in the rubber

washer in the milk container lid

(Figure 23).

The milk is not well frothed. • The milk container lid is dirty. • Clean the milk container lid as

described in paragraph Cleaning the

milk container.

• The milk pointer is incorrectly

positioned.

• Adjust the pointer as described in

chapter MAKING CAPPUCCINO.

1 2 ... 11 12 13 14 15 16 17

Kommentare zu diesen Handbüchern

Keine Kommentare

Bauknecht KMT 9145 PT Wartungshandbuch Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kaffeemacher Bauknecht KMT 9145 PT