• Coffee has been used to factory test the machine and it is therefore completely normal for there to be traces of
coffee in the mill.
• Customize water hardness as soon as possible, following the instructions in paragraph Setting water hardness.
1. Connect the appliance to the mains electricity supply and place the main switch (A23) in position I.
2. The appliance displays “fill tank” in different languages. Extract the water tank (fig. 4), rinse and fill with fresh water
without exceeding the MAX line. Replace and push as far as it will go.
3. Choose the language (the languages scroll through at intervals of about 3 seconds): When the message “press
to TO INSTALL ENGLISH” is displayed, press the
(B7) (fig. 3) for 3 seconds until ENGLISH INSTALLED
is displayed. If you set the wrong language, follow the instructions in the “Setting the language” section. If your
language is not available, select one from those displayed (the instructions refer to English). Then follow the
instructions displayed.
4. Place a cup under the hot water spout (fig. 5). (If the hot water spout is not inserted, the appliance displays
INSERT WATER SPOUT. Attach the spout as shown in figure 6. The machine displays HOT WATER PRESS
”. Press the (B7), a little water comes out of the spout.
5. The display shows TURNING OFF. PLEASE WAIT... and switches off.
6. Slide the machine out, using the handles provided (Figure 7); open the lid, fill the coffee bean container, then close
the lid and push the machine back into the housing.
The coffee machine is now ready for normal use.
WARNING:
Never place pre-ground coffee, freeze-dried coffee, caramelized coffee
or foreign objects in the container, as they could damage the machine
N.B.:
• When using the appliance for the first time, you need to make 4/5 cups of coffee and 4/5cappuccinos before the
appliance gives good results.
• Each time the machine is turned on using the main ON/OFF switch (A23) it runs the SELF-DIAGNOSIS function
and then switches off: to switch back on again, press the (A7) on/stand-by button (Figure 1).
Using the appliance for the first time
14
Each time the machine is switched on, it performs an automatic preheat and rinse cycle which cannot be interrupted.
The machine is ready for use only after completion of this cycle
WARNING:
Risk of burns! During rinsing, some hot water is run off from the coffee
spouts.
To switch the appliance on, press the (A7) on/stand-by button (Figure 1): the display shows HEATING UP. PLEASE
WAIT.... After heating, the display shows another message: RINSING. The machine is at working temperature when
the display shows MEDIUM CUP STANDARD TASTE.
Switching on and preheating
(298 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern